Industrial Wastewater Evaporator Systems

The Water Eater Model 120G is a natural gas or propane heated waste water evaporator. It is available in two models, the Model 120G Carbon Steel version and the Model 120G-SS 316L Stainless Steel version (tank, floor, lid, covers, and stack are 316L SS). Installation is easy consisting of only a 120V electrical hookup, a 10" diameter vent stack, and a 3/4" standard pressure gas line. The unit can be filled three different ways: (1) Using the supplied 2" coupling on the top of the unit; (2) Remove the lid and manually pour in fluid; or (3) Using the optional 70 GPM self priming fill pump. After an initial heat up time of approximately one hour, the Model 120G will evaporate from 15 gallons per hour of water. The Model 120G will automatically shut itself down via a low level control. A secondary high temperature shutoff is also provided. When a cycle is completed the waste material can either be drained or vacuumed out of the unit through the removable lid, with a wet/dry vacuum or pump, or, if it is a solid material, scooped out. To facilitate cleanout, the interior tank of the 120G is sloped towards the 2" outlet. The "U" shape burner tube is located around the perimeter of the process tank allowing access between the tubes. The water evaporator will automatically shut itself down via a low level control. A secondary high temperature shutoff is also provided. When a cycle is completed the waste material can either be drained via a 2" drain opening, vacuumed out of the unit through the removable lid, with a wet/dry vacuum or pump, or, if it is a solid material, scooped out.